AirLink Communications Raven X HSDPA Guía de usuario Pagina 59

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 107
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 58
Raven X HSDPA for Cingular - User Guide, version 2.33 54
AT Commands: UDP
This group includes commands specific to UDP communications.
FIGURE 1. Common : UDP
AIP=n
HOR=n
MDhh
UDP
Allow IP address.
n=0 Allow only the IP address specified in S53 to connect when UDP auto answer is enabled (S82=2).
n=1 Allow any incoming IP address to connect when UDP auto answer is enabled (S82=2).
Note: Always subject to any Friends filters that may be defined.
Half-Open Response - In UDP auto answer (half-open) mode:
n=0 No response codes when UDP session is initiated.
n=1 RING CONNECT response codes sent out serial link before the data from the first UDP packet.
Note: Quiet Mode must be Off.
Default power-up mode for the serial port.
When the Raven X is power-cycled, the serial port enters the mode specified by this command
after 5 seconds. On startup, typing ATMD0 within 5 seconds changes the mode to normal (AT
command) mode.
hh (hex byte)=00 : normal mode
Vista de pagina 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 106 107

Comentarios a estos manuales

Sin comentarios